3DLAC - Glue 80ml

3DLAC STICK can be used on a variety of surfaces where you want to print with a 3D printer. Different materials may have different adhesion, so we recommend that you carry out preliminary tests before printing with the specific technical materials.

It is recommended that you wait until the temperature of the printing plate drops below 30°C before removing prints. If the print cannot be removed, allow it to cool in the refrigerator and the print will come off the print plate more easily.

1.   Shake the product before use.
2.   On a clean and dry surface, turn the container upside down and gently press the applicator onto the warm bed for a few seconds to allow a small amount of product to flow out.
3.   Spread a thin and even layer over the print area for best effectiveness.
4.   Let the product dry and then start printing.
5.   To remove the piece, wait for the print base to cool, then remove the print

Tip:
- Store in a cool, dry place out of direct sunlight. Put the cap on after each use to prevent it from drying out.